1. Fampidirana
This manual provides comprehensive instructions for the installation, operation, and maintenance of your 2GIG Z-Wave 700 Programmable Thermostat, Model 2GIG-STZ-1. This device allows for remote control of your heating and air conditioning systems via a Z-Wave network, in addition to direct control from the thermostat unit.
The 2GIG-STZ-1 thermostat is compatible with most modern HVAC systems, including standard Gas/Electric (2-stagefanana, 2-stage cooling) and Heat Pump systems (3-stagefanana, 2-stage cooling), with support for humidifiers and dehumidifiers.
Sary 1: Eo anoloana view of the 2GIG Z-Wave 700 Programmable Thermostat, displaying current temperature, fan status, and time.
Lafin-javatra fototra:
- Z-Wave Control: Seamless integration with smart home systems for remote access.
- Compatibility isan-karazany: Supports standard gas/electric, heat pump, and humidifier/dehumidifier systems.
- Fametrahana mora: Designed for straightforward replacement of existing thermostats.
- Loharano herinaratra roa: Operates on 4 AA batteries or 24VAC power from your HVAC system.
- Fampisehoana mazava: Large, easy-to-read LCD for temperature control and monitoring.
2. Information momba ny fiarovana
Please read all instructions carefully before installing or operating this thermostat. Failure to follow these instructions could result in property damage, injury, or death.
- Fiarovana herinaratra: Always turn off power to the HVAC system at the circuit breaker before installing or servicing the thermostat.
- BOKYtage Compatibility: This thermostat is designed for 24VAC systems only. It is NOT compatible with 120/240 VAC systems.
- Fametrahana bateria: If powering the thermostat via 24VAC, do not install AA batteries. Batteries are for backup power only if 24VAC is not available or desired.
- Fametrahana matihanina: Raha misy tsy azonao antoka momba ny ampahany amin'ny dingana fametrahana dia manatona teknisiana HVAC mahafeno fepetra.
3. Ny votoatin'ny fonosana
Hamarino fa misy ny entana rehetra ao anaty fonosana:
- 2GIG Z-Wave 700 Programmable Thermostat (Model 2GIG-STZ-1)
- 4 x AA Batterie
- Fitaovana fametrahana (visy sy vatofantsika rindrina)
- Torolàlana fametrahana (ity antontan-taratasy ity)
- Torolalana fanombohana haingana
4. Fametrahana
4.1. Miomana amin'ny fametrahana
- Turn off power to your heating and cooling system at the main circuit breaker.
- Remove your old thermostat's cover. Take a picture of the wiring connections for reference.
- Label each wire with the corresponding terminal letter from your old thermostat.
- Disconnect the wires and remove the old thermostat's mounting plate.
4.2. Mounting the Back Panel
The back panel of the 2GIG-STZ-1 thermostat serves as the mounting base and wiring terminal.
- Feed the wire cable from the wall through the access hole in the new mounting plate.
- Use the provided wall anchors and two Phillips screws to secure the back panel to the wall.
- Ensure the back panel is level for proper aesthetic alignment.
Figure 2: Illustration of mounting the back panel, showing wire access and screw locations.
4.3. Fametrahana tariby ny Thermostat
Connect the labeled wires to the corresponding terminals on the thermostat's back panel. Refer to your old thermostat's wiring diagram and the labels you made. The 2GIG-STZ-1 supports the following configurations:
- Standard Gas/Electric HVAC: Hatramin'ny 2-stagefanana, 2-stage mangatsiaka.
- Heat Pump HVAC: Hatramin'ny 3-stagefanana, 2-stage mangatsiaka.
- Humidifier/Dehumidifier Support: Dedicated terminals available.
For 24VAC power, ensure both "R" and "C" wires are connected. If a "C" wire is not available, the thermostat can be powered by 4 AA batteries, but it will not repeat Z-Wave signals in your network.
4.4. Fametrahana ny tontonana anoloana
Once wiring is complete, attach the thermostat's front panel to the mounted back panel.
- Align the front panel with the back panel.
- Gently press the front panel onto the back panel until it snaps securely into place around all edges.
Figure 3: Illustration of attaching the front panel to the back panel, showing the snap-together mechanism.
After the front panel is attached, restore power to your HVAC system at the circuit breaker.
5. Torolàlana miasa
5.1. Famelomana ny Thermostat
The thermostat can be powered by 24VAC from your HVAC system (if "R" and "C" wires are connected) or by four (4) AA batteries. If 24VAC is supplied, batteries are not required for operation but can serve as a backup. If only battery-powered, the thermostat will not function as a Z-Wave repeater.
5.2. Fanaraha-maso fototra
The thermostat features a clear LCD display and intuitive buttons for control:
- bokotra FAN: Cycles through fan modes (Auto, On).
- Bokotra MODE: Cycles through system modes (Heat, Cool, Auto, Off, Em Heat).
- zana-tsipìka ambony/midina: Adjusts the temperature setpoint.
5.3. Fanitsiana ny maripana
Tsindrio ny Up or Midina arrow buttons to increase or decrease the desired temperature setpoint. The display will show the new setpoint temporarily.
5.4. Z-Wave Network Integration
To integrate the thermostat into your Z-Wave network, refer to your Z-Wave hub's instructions for adding new devices. The 2GIG-STZ-1 is a Z-Wave 700 series device, offering enhanced range and battery life. Once paired, you can control the thermostat remotely via your Z-Wave smart device or hub interface.
Fanamarihana: For optimal Z-Wave performance and to function as a Z-Wave repeater, the thermostat should be powered by 24VAC.
6. Fikojakojana
6.1. Fanadiovana ny Thermostat
Mba hanadiovana ny thermostat, fafao moramora ny ivelany amin'ny malefaka, damp cloth. Do not use abrasive cleaners, solvents, or spray cleaners directly onto the thermostat, as this may damage the unit or its electronic components.
6.2. Fanoloana bateria
If your thermostat is battery-powered, replace the four (4) AA batteries when the low battery indicator appears on the display. Ensure to use fresh, high-quality alkaline batteries. If the thermostat is 24VAC powered, battery replacement is not typically required for operation, but batteries can be installed for backup power.
- Carefully remove the front panel of the thermostat from the back panel.
- Esory ny bateria AA taloha.
- Insert four new AA batteries, ensuring correct polarity (+/-).
- Reattach the front panel to the back panel until it snaps securely.
7. Famahana olana
If you encounter issues with your 2GIG-STZ-1 thermostat, refer to the following common problems and solutions:
| OLANA | Antony mety hitranga | vahaolana |
|---|---|---|
| Thermostat has no power/blank display. | No 24VAC power; dead batteries; incorrect wiring. | Check circuit breaker for HVAC system. Replace AA batteries if battery-powered. Verify "R" and "C" wire connections. |
| HVAC system not responding to thermostat. | Incorrect wiring; system mode set to "Off"; Z-Wave communication issue. | Double-check wiring. Ensure system mode is set to "Heat", "Cool", or "Auto". Re-pair with Z-Wave network if controlling remotely. |
| Temperature swing is too wide. | Thermostat differential settings. | Consult the advanced settings menu (if available) or your Z-Wave controller for options to adjust temperature differential. This setting controls how far the temperature deviates from the setpoint before the system activates. |
| Cannot connect to Z-Wave network. | Thermostat too far from hub; interference; incorrect pairing procedure. | Ensure thermostat is within range of the Z-Wave hub or a repeater. Follow Z-Wave hub's specific instructions for inclusion/exclusion. Ensure thermostat is 24VAC powered to act as a repeater. |
8. Famaritana
| endri-javatra | antsipirihany |
|---|---|
| Laharana modely | 2GIG-STZ-1 (also known as 2GIG-STZ1-345) |
| mifanentana | 24VAC 3H/2C non-heat pump/heat pump systems with humidifier/dehumidifier support. Not compatible with 120/240 VAC systems. |
| Room Temperature Measurement Scale | Fahrenheit / Celsius (user selectable) |
| Efitrano mari-pana | 32 hatramin'ny 122 degre F (0 hatramin'ny 50 degre C) |
| Fahamarinan'ny maripana | +/- 1 degrees F (0.5 degrees C) |
| Heat Set Point Range | 32 - 90 degrees F (0 - 32 degrees C) |
| Cool Set Point Range | 61 - 122 degrees F (16 - 50 degrees C) |
| Fametrahana fanapahan-kevitra | 1 degre F (0.5 degre C) |
| Fanaraha-maso ny mpankafy | Auto/On |
| Herin'aratra | AC: 18-26VAC 60Hz (R and C); 4x AA size battery (6VDC) |
| Temperature miasa | 32 hatramin'ny 122 degre F (0 hatramin'ny 50 degre C) |
| Hamandoana miasa | 10-90 percent Non-Condensing |
| refy (H x W x D) | 5.75 x 4.5 x 1 in (14.6 x 11.4 x 2.5 cm) |
| lanja | 1.06 lbs (0.48 kg) |
| fifandraisana | Z-Wave (série 700) |
| Karazana fampisehoana | LCD misy backlight |
9. Fampahalalana momba ny fiantohana
The 2GIG Z-Wave 700 Programmable Thermostat (Model 2GIG-STZ-1) comes with a Garantie 1 taona voafetra from the manufacturer. Please retain your proof of purchase for warranty claims. For specific terms and conditions, refer to the warranty documentation included with your product or contact 2GIG customer support.
10. Fanohanana ny mpanjifa
For further assistance, technical support, or warranty inquiries, please contact 2GIG customer support. You may also refer to the support resources provided by your Z-Wave hub manufacturer for integration-specific questions.
Fanamarihana: Manufacturer support policies may vary. Access to detailed manuals or direct support might be restricted to authorized dealers or installers in some cases.
