Generic Remote Control Instruction Manual

Sava lalana

This manual provides essential instructions for the proper setup, operation, and maintenance of your new Generic replacement remote control for Twin-Star ChimneyFree Electric Fireplace Heaters. This remote is designed as an infrared replacement. Please ensure your original remote control matches the appearance of this replacement unit for full compatibility. No programming or setup codes are required for operation.

Fametrahana: Fametrahana bateria

Your remote control requires two (2) AAA batteries (not included) for operation. Follow these steps to install the batteries:

1. Tadiavo eo an-damosin'ny fanaraha-maso lavitra ny fonon'ny efitrefitra bateria.
2. Tsindrio midina ny takelaka ary ahintsano midina ny fonony mba hanesorana azy.
3. Ampidiro ny batteries AAA roa, ary ataovy izay hahazoana antoka fa mifanaraka tsara amin'ny marika ao anaty efitrano ny terminal tsara (+) sy ratsy (-).
4. Atsofohy amin'ny toerany ny fonon'ny efitry ny bateria mandra-pikitika tsara.

Image: Back of the remote control with the battery compartment open, illustrating the correct placement for two AAA batteries.

Zava-dehibe: Soloy foana ny bateria roa miaraka. Aza afangaro ny batterie taloha sy vaovao, na karazana batterie samihafa.

Torolàlana miasa

Point the remote control directly at the infrared receiver on your electric fireplace heater. Ensure there are no obstructions between the remote and the fireplace.

Sary: Front view of the remote control, highlighting the main function buttons.

• Bokotra Hery (O): Press this button to turn the electric fireplace heater ON or OFF.
• Flame Button (): Use this button to adjust the flame brightness or effect settings. Multiple presses may cycle through different flame options or turn the flame effect off.
• Heater Button (): Activates or deactivates the heating function. Some models may allow for temperature adjustment with repeated presses or dedicated temperature buttons.
• Button fameram-potoana (): Sets the automatic shut-off timer for the fireplace. Each press typically cycles through various time intervals (e.g., 30 minutes, 1 hour, 2 hours, etc.) or turns the timer off.

fikarakarana

• Fanoloana bateria: Replace batteries when the remote's range decreases or it stops responding. Refer to the "Setup: Battery Installation" section for instructions.
• Fanadiovana: To clean the remote control, wipe it with a soft, dry cloth. Do not use abrasive cleaners, solvents, or wet cloths, as these can damage the remote's surface or internal components.
• fitahirizana: Raha tsy hampiasaina mandritra ny fotoana maharitra ny fanaraha-maso lavitra dia esory ny bateria mba hisorohana ny fivoahan'ny rano sy ny fahasimbana mety hitranga.

Fanamboarana

• Lavitra tsy mamaly:
  • Jereo raha ampidirina tsara amin'ny polarity marina ny bateria.
  • Soloy ny bateria AAA vaovao.
  • Ensure there is a clear line of sight between the remote control and the fireplace's infrared receiver. Remove any obstructions.
  • Confirm that the fireplace heater is powered on and plugged into a working electrical outlet.
• Sarobidy voafetra:
  • Replace the batteries. Weak batteries can reduce the remote's effective range.
  • Ensure you are within the recommended operating distance and pointing directly at the fireplace.
• Bokotra tsy mandeha:
  • Verify that the remote is compatible with your specific fireplace model. This remote is an infrared replacement and should visually match your original.
  • Clean the remote's surface, especially around the buttons, to ensure no debris is interfering with button presses.

fepetra arahana

Warranty sy fanohanana

Information regarding specific warranty terms or direct customer support for this Generic replacement remote control is not available in this manual. For any issues not covered in the troubleshooting section, please refer to the seller's return policy or contact the retailer where the product was purchased.